Redditor spilled water on his favorite computer keyboard (like so many of us have done before). The damage was minimal, but after drying it out, one key still wouldn't work. He didn't want to throw out the whole keyboard over one broken key, so he opened it up to find out what was causing the problem. He noticed a small corroded area on the circuit board and tried fixing it with aluminum and a copper wire, but to no avail.

• How To Fix Keyboard Keys
• Fix Keyboard

Tekken 7 gamepad, Keyboard, Mouse not working. Tekken 7 gamepad, Keyboard + Mouse not working. Game Update — Patch Fix Setup tekken 7. 1) Download the patch.

Some research suggested that graphite may be a good conductor, in lieu of expensive conductive ink,. The graphite from a regular pencil was enough to bridge the gap in the circuit and get the key working again.

The fix is really simple. All you have to do is draw over the corroded area a few times with a pencil. You can see the graphite a little to the right of the pencil lead in the photo below. This trick isn't just good for keyboards—it should fix light damage to the PCB in other electronics like a GPS, game controller, or remote control. Depending on the design, it can also work for a laptop keyboard if the flexible circuit board isn't too hard to get to due to other components.

Just keep in mind that the circuit paths may be printed on both sides. Have you ever tried an unconventional fix like this one?

Share it with us in the comments below. Image via Shutterstock Take the Gadget Hacks Upgrade Quiz Related. It worked like magic!!

How To Fix Keyboard Keys

I had the exact same problem - my cat spilled water over my keyboard - the keyboard stopped working - so I opened it up and dried the circuit sheets (it has 3 sheets inside). After that everything seemed to be working again but after few days i realized that only one key isn't working - so I opened up again the keyboard and noticed that the line on the circuit sheet of that key is corroded - so I applied graphite and now it is working again:) Just make sure you apply enough graphite on the side where it's printed on and it should work like charm Reply. I always had a very curious personality and love taking things apart to find the mode of failure and come up with ways to fix it. When I was 14 years old my friend was throwing away this small musical keyboard because he said the keys worked but it was stuck on piano sounds and that the buttons to change the sound with didn't work.

He told me I could have it if I wanted it. I took it home and ripped into its guts. After following the printed circuit leading up to the contacts for the switch pads I found a section that appeared to be damaged possibly due to moisture damage. This was before the days of Internet so I had to come up with a solution.

I didn't own a soldering iron so trying to solder a bridge was out of question. While brainstorming I remembered that sticking a pencil into an outlet could shock a person since graphite is conductive. So after carefully scraping off the non conductive lamination off the non damaged sections of that printed circuit to make sure I could make good contact on both ends of the damaged section, I took a fine point pencil and went over the damaged section a bunch of times making sure I was making good contact. I put it back together and BAM! All the buttons came back to life. I kept it for a while and had a little fun with it and then decided to give it back to my friend. He was very happy to have his keyboard back in working order.

Fix Keyboard

I have used that trick on a whole bunch of circuit boards with great success. The only time it doesn't work is if the damaged section is long or if the circuitry is sensitive to resistance since graphite has a higher resistance than copper which a lot of circuit boards use.